Audio Technica AT-LP2D-USB Bedienungshandbuch PDF herunterladen (Seite 4)

Assembling the Turntable

The AT-LP2D-USB requires some assembly before first use.

IMPORTANT: Do not connect the AC power cord until

assembly is complete.

1. Carefully place the turntable platter on the center

spindle, making certain the platter is fully seated on

the spindle.

2. While holding both ends of the red tape ribbon on the

turntable belt, carefully pull the belt over the motor

pulley (Fig. 2a). (If the belt drops off, remove the

turntable platter and put the belt back on it, as

described on page 7.)

3. Once the belt is seated in the pulley's groove, carefully

remove the ribbon. Make certain the belt is not twisted.

4. Place the turntable mat on top of the turntable

platter (Fig. 2b).

5. If desired, the hinged dust cover may be removed. Hold

both sides of the dust cover and pull upward

gently

and evenly

to detach the cover from the turntable

(Fig. 2c). Keep the cover in a safe, clean place.

6. To re-install the dust cover, guide the dust cover hinges

into the two hinge receptacles located at the back of

the turntable housing

Connecting to Computers with USB Input

The USB cable (included) connects your AT-LP2D-USB

turntable to your computer without need for special drivers.

Refer to included software guide (also available online at

www.audio-technica.com) before connecting the turntable

to your computer.

Setting the Pre-amp (Phono/Line) Switch

For increased flexibility of use, this turntable has an internal

stereo phono pre-amplifier. The Pre-amp Selector (Phono/Line)

Switch is located on the back of the turntable. If the stereo

system you are using has a PHONO input, set the Pre-amp

Selector Switch to the “PHONO” position. If your stereo

system does not have a PHONO input, set the Pre-amp

Selector Switch to the “LINE” position and connect the

turntable's output cables to the AUX or other high-level input

on your stereo system (described later) (Fig. 3).

NOTE: If you are using the USB cable to connect your turntable

to a computer, the Pre-amp Selector Switch setting has no

effect on USB operation.

2b Record mat

2c Dust cover removal

Figure 2 Assembling the Turntable

2a Drive belt

Red ribbon

Motor spindle

Drive belt

Setup & Operation

PHONO

LINE

USB

LINE

PHONO

“AUX”

PHONO

Input

Jacks

Pre-amp

Selector

Switch

Stereo System

White

Red

Figure 3

1 2 3 4 5 6 7 8 9 ... 30 31

Kommentare zu diesen Handbüchern

Keine Kommentare

Audio Technica AT-LP2D-USB Bedienungshandbuch Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drehscheibe Audio Technica AT-LP2D-USB